Let the joint locate the winding. Specify the recess precisely. sales@ferrobend.com +91-8369719424

Basic sealing element

Spiral Wound Gasket Without Rings

A spiral-wound sealing element without inner or outer rings. The mating joint must provide suitable location, support and compression control.

Spiral Wound Gasket Without Rings, showing the winding and locating arrangement

THE CONSTRUCTION

Winding and filler.
No separate guide rings.

Profiled metal strip and soft filler form the sealing element. Without separate support rings, this construction relies on correctly designed flange geometry to hold and compress the winding.

Tongue-and-groove, male-and-female or flat-to-recess joints may use this arrangement when the joint design permits. It is not a direct substitute for a ring-guided gasket on an open raised-face joint.

Compare all six configurations
ArrangementNo inner or outer ring
Location / supportLocation by the joint
Design requirementControlled recess depth

TECHNICAL REFERENCE

Standards & material specifications

Match the construction, joint geometry and component materials.

Dimensions & joint requirements

Spiral Wound Gasket Without Rings dimensional and joint references
Approved joint drawingDefine winding ID/OD, thickness, recess width and depth, clearances and the compression stop.
ASME B16.20The published pipe-flange scope covers raised and flat faces. A ringless recessed joint needs an approved drawing; do not assume a standard dimensional configuration.
Flange geometryThe mating seats must support the sealing width and control compression. A nominal flange size alone does not define a ringless gasket.

Omitting rings must be an approved joint-design decision. Do not infer interchangeability or a pressure rating from the winding dimensions.

Component material requirements

Spiral Wound Gasket Without Rings material references
Metal windingFor a 316L stainless winding, specify UNS S31603 strip and the ordered material specification, such as ASTM A240/A240M. Select the filler separately.
Soft fillerFlexible graphite or PTFE are established options. Specify the actual grade and verify chemical compatibility, oxidation conditions and service limits.
Component identificationSpecify winding alloy and filler separately. Metal-only reinforcing turns at the winding edges are not separate solid inner or outer rings.

Material capability does not establish complete-joint capability. Confirm the standard edition, component marking and service conditions; illustration colours are not material identification. Construction references: Flexitallic selection guide · Teadit construction guide.

UNDERSTAND THE ARRANGEMENT

Construction details that matter.

Illustrative views of this configuration. Geometry, proportions and colours are schematic; use the specified standard or approved drawing.

Wound sealing element — Spiral Wound Gasket Without RingsSchematic construction detail. Colour, proportions and any illustrated hole count do not specify a supplied gasket.Metal + fillerNo separate guide rings
01 / Construction detail

Wound sealing element

The profiled metal strip and soft filler form the active seal. Edge reinforcement remains part of the winding, not a separate ring.

Flange location — Spiral Wound Gasket Without RingsSchematic construction detail. Colour, proportions and any illustrated hole count do not specify a supplied gasket.Illustrative seated jointJoint geometry controls location
02 / Construction detail

Flange location

The drawing defines how the groove or recess locates and supports the sealing element. Confirm both mating faces.

Compression control — Spiral Wound Gasket Without RingsSchematic construction detail. Colour, proportions and any illustrated hole count do not specify a supplied gasket.Illustrative seated jointJoint geometry controls locationDepth
03 / Construction detail

Compression control

Control the recess and mating geometry for the specified seated thickness. Do not use a general torque or compression value.

Define the Right Spiral Wound Configuration

Share the flange or joint drawing, ring arrangement, component materials, service conditions and quantity.

Request a Quote